The Rinnai INFINITY N-Series are condensing gas continuous flow water heaters designed for commercial applications and high hot water demand residential installations.
Available as an external unit (N56kWe) or an internal unit (N56kWi).
Features
Suitable for
External commercial and residential applications (N56kWe external model only).
Internal commercial and residential applications (N56kWi internal model only).
Mains and medium pressure systems. Hard or acidic water will need to be treated to use this product.
Condensing technology
Utilises a secondary heat exchanger to drive further thermal efficiency by extracting heat from combusted flue gases, making the N-Series models 97% efficient.
Not suitable
- as spa or swimming pool heater
- for hydronic applications
- for domestic ring main applications1
1 The N-Series internal pump controller is not suitable for domestic ring main applications as it does not allow the system to turn off. This means the ring main continually operates, which can cause high energy use and cost, and can be a noise nuisance, especially at night, when people are sleeping. We do however have a plumbing configuration solution if a domestic ring main is required, click here for more information.
16-209
MJ/h
55.5
kW
97%
Available for Natural Gas or LPG, specify at the time of purchase
Gunmetal grey
55 ºC* (can be preset to deliver up to 85 ºC**)
* Models made before May 2020, serial number before 20.05000001 were preset to 75 ºC
** Maximum temp. for circulating systems is 65 ºC
1.5-37 litres per minute. Nominal water capacity is 32 litres per minute at a 25 ºC rise (1920 L/h)
Fitted as standard. Frost protection operates automatically, as long as the appliance is connected to the electrical power supply, by activating when the temperature inside the unit drops below 3.5 °C, and turns off once the temperature inside the unit reaches 7 °C.
Direct electronic ignition
IPX5
NG - 1.13kPa, LPG - 2.75 kPa
3.5 kPa (maximum standing pressure under abnormal intermittent conditions is 5.0 kPa).
In the case of commercial metering, (i.e. 35-37 kPa coming in), there may be a requirement to regulate the incoming pressure down.
Nominal operating pressure: 300-1000 kPa
Minimum operating water flow will depend on setpoint and inlet temp.
Internal models 49 dB(A), external model 54 dB(A). Some people are susceptible to low level noise. This needs to be considered if locating an appliance near a bedroom.
Co/CO2 for nominal conditions:
29 kg
Energy Safety Supplier Declaration of Compliance: Declaration number - 1911920196
January 2020
Can an N-Series be used to replace am older unserviceable Rinnai INFINITY in a bank of electronically connected appliances?
Yes, as long as the N-Series is a secondary unit and not the primary. Refer to the N-Series Connection to Older Models document in the Downloads Tab for more information (only accessible to TradeSmart users).
This article clarifies some of your frequently asked questions amidst all the confusion about the future of gas.
Read Article
Rinnai strives to make sustainable improvements across all areas of our business as we hope to shape and influence the future of the gas industry. We are proud to announce that we have developed the world’s first 100% hydrogen combustion technology for residential water heaters.
Read Article
Hot water can make up a third of our electricity bill! This ends up being a lot of amount of money as time goes by. With a few small changes in our daily habits and routines, we can cut down on these costs.
Read Article
