*Does not include flue—sold separately.
** LPG models have sold out, replaced by the new FT3 model**
A heating solution that delivers excellent air quality and efficient heating to any room.
* Louvre component of the heater will still be hot
All Energysaver models come with features that may reduce the likelihood of an allergic reaction for customers with asthma or allergies.
Suitable for domestic heating appliance. Suitable for living rooms, bedrooms, and open plan areas.
Heating areas (up to)
- Upper North Island 49 m²
- Central and lower North Island 34 m²
- South Island 29 m²
The appliance must not be built in.
Stainless steel bunsen burner
High efficiency forced flue convection heater supported by electronic timers
Lower bottom panel, left hand side
230 V 50 Hz with supply cord and 3-pin plug
Centrifugal drum type fan
15 mm BSP male thread
Rinnai electronic modulating gas control valve
Direct continuous spark electronic ignition—no pilot
Approx. 41 W (on high), < 1 W on standby
Overheat switch, fusible link, flame failure device, electrical fuse, and power failure
16-26 °C by 1 °C increments
To change the temperature scale:
1. The heater must be off.
2. Press the Timer 1 and Timer 2 buttons at the same time for about 5 secs. The display will show °C or °F.
3. Use the arrow keys to select the temperature scale.
4. Press the ON/OFF button.
ES: Supplier Declaration of Compliance
• Declaration Number - 1408020132
The Healthy Homes Standards in New Zealand were set in 2019 to protect tenants with requirements for heating and insulation. How can you make sure your house complies with the healthy home standards? Learn it all in our guide here.Read Article
If you’ve ever worked in an office environment, or you battle with a spouse over who gets control of the Heat Pump controller, you will be no stranger to how uncomfortable your home can be when the temperature isn’t quite right.Read Article