*Does not include flue—sold separately.
All Energysaver models come with features that may reduce the likelihood of an allergic reaction for customers with asthma or allergies.
A centralised control option, remote switching kit (R1349), is available for this model for installations where there is a need to have an external control to switch the unit on and off, for example in schools, community halls, churches.
Suitable for commercial heating appliance suitable for open plan areas such as classrooms and churches.
Heating areas (up to)
- Upper North Island 140 m²
- Central and lower North Island 97 m²
- South Island 82 m²
Available for Natural Gas or LPG. Specify gas type at time of purchase
Stainless steel bunsen burner
High efficiency forced flue convection heater supported by electronic timers
Lower bottom panel, right hand side
230 V 50 Hz with supply cord and 3-pin plug
Centrifugal drum type fan
15 mm BSP male thread
Rinnai electronic modulating gas control valve
3.0 L (rate of evapouration 300 ml/hr)
Direct continuous spark electronic ignition—no pilot
Approx. 123W on high, < 1 W on standby
Overheat switch, fusible link, flame failure device, electrical fuse, and power failure
16-26 °C by 1 °C increments
To change the temperature scale:
1. The heater must be off.
2. Press the Timer 1 and Timer 2 buttons at the same time for about 5 secs. The display will show °C or °F.
3. Use the arrow keys to select the temperature scale.
4. Press the ON/OFF button.
ES: Supplier Declaration of Compliance
• Declaration Number - 1516320137
How do you choose between convective or radiant heating? A good start is to read this article.Read Article