Internal continuous flow gas hot water heater with status monitor, preset to 75 °C. Balanced flued, room sealed fan assisted appliance.
Suitable for mains and medium pressure residential and commercial internal applications. Also applications requiring higher hot water temperatures, can be set up to 85 °C. Hard or acidic water will need to be treated to use this product.
Available for NG or LPG. Gas type specified at time of purchase.
195 MJ/h or 54 kW
Hot water capacity: 2.4-32 L/min
Nominal water capacity: 26 L/min
Direct electronic ignition
NG: 1.00, 1.70
LPG: 0.75, 1.15
3.5 kPa (maximum standing pressure under abnormal intermittent conditions is 5.0 kPa).
In the case of commercial metering (i.e. 35-37 kPa coming in), there may be a requirement to regulate the incoming line pressure down.
Normal 53 W (NG) and 57 W (LPG)
Standby 2 W
Automatic frost protection 74 W
Valve opens at 2060 kPa and closes at 1470 kPa
Flame failure, boil-dry protection, overheat protection (OHS), fusible link, pressure relief valve, combustion fan RPM check
40, 42, 50, 55, 65, 75, 85 °C
Water flow sensor, electronic water flow control devices, and electronic by-pass flow control device
Nominal operating pressure: 190-1000 kPa
Minimum water flow: 2.4 L/min
2011, superseded by the HDi200 internal
Energy Safety Supplier Declaration of Compliance: Declaration number - 971120094
This article clarifies some of your frequently asked questions amidst all the confusion about the future of gas.Read Article
Rinnai strives to make sustainable improvements across all areas of our business as we hope to shape and influence the future of the gas industry. We are proud to announce that we have developed the world’s first 100% hydrogen combustion technology for residential water heaters.Read Article
Hot water can make up a third of our electricity bill! This ends up being a lot of amount of money as time goes by. With a few small changes in our daily habits and routines, we can cut down on these costs.Read Article