Rinnai INFINITY® Error Indication Switch

Rinnai INFINITY® Error Indication Switch

The Rinnai INFINITY error indication switch is a volt-free normally open or normally closed switch. The switch will shift to the reverse position when there is an active error in the water heater.

The switch is intended to be connected to a monitoring system such as a BMS (building management system) or other visual or audible error indication system.

One error indication switch is required for each Rinnai INFINITY unit—installed inside the unit.

Suitable for

  • R1070 error switch is suitable for HD models*
  • REUOPU3 error switch is suitable for N-Series models, this kit contains an additional component (accessory cable main wiring loom)
* Also suitable for the EF250 and EFi250 models which have been superseded by the N-Series

Switch rating
The error indication switch will switch the following maximum loads:

- Voltage (AC or DC): 24 Volts
- Current: 1 Amp

Systems requiring loads greater than this should be configured via an external relay.

Ducted Gas Heating Service Centre

Ducted Gas Heating Service Centre
Operating 5 days a week, 8am to 5pm, Monday to Friday our New Zealand based customer service centre provides nothing but top quality. If you need to book in a Ducted Gas Heating service, we have a team of providers fully trained and equipped with diagnostic tools to service your appliance when you need them. 

Architects Portal

*Architects* Portal

Are you an Architect, Designer or Specifier?

We have everything you need to support your design process including CAD & BIM content. Check out everything you need from one easy Architects and Designers portal.

Enquire about a product

We’re happy to help with anything, big or small. Please fill out the short form below and we’ll get back to you within 24 hours.

Please enter your name Please enter your email address Please enter a subject Please enter a message

Where to Buy

Find a Rinnai reseller near you: